Downstream Bypass 5 to 8 GPM @ 20% Chem Injector 3/8" QCs & Plated Fittings

Overview

This is a fully assembled 5-8 GPM downstream chemical injector with a plated bypass ball-valve and 3/8" quick couplers, built for cold or hot water pressure washers. It draws chlorine or other cleaning chemical downstream (after the pump, so nothing corrosive runs through it) at a 20% fixed rate using a 2.1mm metering orifice, then lets you flip the ball-valve to bypass and rinse at full pressure with no flow restriction. The larger 3/8" flow path holds more flow and pressure than a typical injector, so you reach higher and farther with less pressure loss. An economical entry into soft-wash for anyone running an existing high-flow machine.

What's included

• 5-8 GPM flow range
• 20% fixed downstream injector, 2.1mm orifice
• Plated ball-valve for chemical/bypass switching
• 3/8" plated quick couplers for 3/8" ID hose
• Stainless steel inlet metering ball
• 48" chemical inlet suction hose with strainer
• 24" high-pressure bypass hose
• Zinc-plated steel fittings
• Chemical does not run through the pump
• Completely assembled and ready to use

Specifications

Flow Range

5-8 GPM

Chemical Draw

20% fixed

Injector Orifice

2.1mm

Quick Couplers

3/8" plated

Hose Compatibility

3/8" ID

Ball-Valve

Plated, SS inlet metering ball

Chemical Inlet Hose

48" x 1/4" suction hose with strainer

Bypass Hose

24" high-pressure

Fittings

Zinc-plated steel

Water Temperature

Cold and hot water